Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Information on safety
2.1
Safety messages and hazard categories
These operating instructions contain safety messages to alert you to poten-
tial hazards and risks. In addition to the instructions provided in these oper-
ating instructions, you must comply with all directives, standards and safety
regulations applicable at the installation site of the product. Verify that you are
familiar with all directives, standards and safety regulations and ensure com-
pliance with them prior to using the product.
Safety messages in these operating instructions are highlighted with warning
symbols and warning words. Depending on the severity of a hazard, the
safety messages are classified according to different hazard categories.
NOTICE indicates a hazardous situation, which, if not avoided, can result in
equipment damage.
2.2
Intended use
The product may only be used for installation in the interstitial space of a dou-
ble-walled tank or a comparable application for monitoring of the following liq-
uids:
•
Fuel oil EL as per DIN 51603-1 and as per DIN SPEC 51603-6 with 0 -
100 % fatty acid methyl ester (FAME) as per EN 14214
•
Fuel oil DIN SPEC 51603-6 EL A Bio 5 to 15 with an addition of fatty acid
methyl ester (FAME) as per EN 14214 without additional alternative com-
ponents
•
Diesel fuel as per EN 590 with up to 7 % fatty acid methyl ester (FAME)
as per EN 14214
•
Biodiesel with up to 100 % fatty acid methyl ester (FAME) as per
EN 14214
•
Lubricating oils, hydraulic oils, thermal oils Q alloyed or not alloyed, with
flash point > 55 °C
•
Lubricating oils, hydraulic oils, thermal oils Q, used, with flash point
greater > 55 °C (origin and flash point must be proven by operator)
•
Vegetable oils, for example cottonseed oil, olive oil, colza oil, castor oil or
wheat germ oil in any concentration
Information on safety
NOTICE
EN
LS-03
3
Publicité
Table des Matières
