Information On Safety - afriso LS-03 Notice Technique

• Ethylene-glycol (CH2OH) as antifreeze for radiators
• Photo chemicals (standard), usage concentration (new and used), with a
density of up to 1.15 kg/dm³
• Ammonium hydroxide (solution) NH4OH, up to saturated solution
• AdBlue® with a density of up to 1.15 kg/dm³
- (AdBlue® is the same as "NOx reduction agent AUS 32" and "urea solu-
tion 32.5 %")
• Oils, water and liquids to which the probe is chemically resistant and
whose density is at least 0.7 kg/dm³ and no more than 1.15 kg/dm³
This means that almost all liquids can be detected whose flash point is higher
than > 55 °C and whose compatibility with the materials of the wetted parts
has been proven.
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
• All directives, standards and safety regulations applicable at the installa-
tion site of the product
• All conditions and data specified for the product
• The conditions of the planned application
In addition, perform a risk assessment in view of the planned application,
according to an approved risk assessment method, and implement the
appropriate safety measures, based on the results of the risk assessment.
Take into account the consequences of installing or integrating the product
into a system or a plant.
When using the product, perform all work and all other activities in conjunc-
tion with the product in compliance with the conditions specified in the oper-
ating instructions and on the nameplate, as well as with all directives, stand-
ards and safety regulations applicable at the installation site of the product.

Information on safety

EN
LS-03
4