Know Your Product - Ryobi EMS305RG Traduction Des Instructions Originales

KNOW YOUR PRODUCT

See page 162 - 163.
1. Handle
2. Power switch
3. Safety lock handle
4. Upper guard
5. Saw blade
Lower guard
7. Clamp
8. Main fence
9. Turntable
10. Base
11. Table insert
12. Turntable lock handle
13. Balancing foot
14. Laser switch
15. LED switch
Bracket stop
17. Lower guard cover
18. Sliding fence
19. Mounting hole
20.
21. Screws for adjusting the bevel angle limit stop
22. Spindle lock knob
23. Top handle
24. Dust bag
25. Cutting depth adjustment knob
Linear rod stop knob
27. Winding support
28. Bevel angle lock knob
29.
30. Screws for adjusting mitre angle
OPERATION
The product features a moving saw blade that can be set at
various angles by the operator when cutting a work piece
be operated by only one person to prevent unintentional
contact with the moving saw blade.
The principles for safe operation of the product are as
follows:
Maintain saw, blades and work area in good condition.
Secure the mitre saw base to a sturdy work bench.
The product may move and tip if it is not adequately
secured.
Set up and lock the cutting angles and depth before
making the cut.
Secure the work piece to the mitre saw base. Use the
clamp provided and, where necessary, use additional
clamps or holding mechanisms to prevent unintentional
movement of the work piece while cutting.
Check that the operation of the blade guards are
not restricted by the position of the work piece.
Ensure that the fence and other parts of the product
will not be cut as the blade lowers to the cutting
position.
4
Start the motor and allow the blade to reach full speed
before slowly lowering it to cut the work piece. Slide
the blade assembly backwards and/or forwards to
complete the cut as necessary.
Allow the blade assembly to rise to its upper position
where the blade guards are fully closed. Switch off the
motor and allow the blade to come to a complete stop
before removing the work piece or off-cuts, or before
reaching into the area of the blade.
set on the product matches the angle to be produced on
the work piece. Check this on a discarded piece of wood
by using a carpenter's set or mitre square.
WARNING
The manufacturer strongly recommends that the product
is always securely mounted to a bench top.
top by the four nuts, bolts and washers provided, the
without the possibility of it tipping over. If the product is
not secured properly, the product may over balance when
large bevel angles are selected.
There is also an adjustable screw (balancing foot) that
that the product is resting upon. This will also prevent the
of the slide and bevel. Beware, this part of the saw table
moves when different mitre angles are selected, so the
screw needs to be frequently adjusted and reset.
MAINTENANCE
Do not modify the product in any way or use accessories
not approved by the manufacturer. Your safety and that
of others may be compromised.
Do not use the product if any switches, guards or
other functions does not work as intended. Return to
an authorised service centre for professional repair or
adjustment.
Do not make any adjustments whilst the saw blade is
in motion.
Always make sure the power plug has been
removed from the mains power source before
making adjustments, lubricating or when doing any
maintenance on the product.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
The blade is very hot after use. Wear gloves or allow to
cool before maintenance or cleaning procedures.
Clean out accumulated dust using a brush or vacuum
cleaner. Do not use compressed air.
English