Assembly Recommendations - dirna Bergstrom bycool green line INTEGRAL POWER Instructions De Montage

INTEGRAL POWER
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
Warning
!
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Integral Power on roof, take into account
that, normally, cabins equipped with a hatch have a
strong enough structure to hold equipment weight.
However, if it is not the case and it is necessary to
carry out a cut in the roof or, although it has a hatch, the
material is not resistant enough (if roof is made of fibre,
plastic, etc...), it is the installer who will have to decide,
under his responsibility, if it is necessary to reinforce
the roof to avoid possible deformations, breaks, water
entries, etc., habilitating the means required to stop it
from occurring.
Set of Torx keys
Set of Allen keys
Ø10 Spanner
Scissors
Flexometer
Ø10 Wrench
Phillips screwdriver / screwdriver
Ø35 Circular saw
Ø7 Drill
Sabre saw
Documentation included
Mounting instructions
User's guide
Warranty
!
The installing personnel must have a sufficient training
in vehicles air conditioning.
!
dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Unit pre-loaded with refrigerant gas R-134a, (I.P. 12 V.
500 g. - I.P. 24 V 500 g) (Do not touch the refrigerant
gas circuit).
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
10
Tools
220AA35151
220AA10005
220AA10010
Warnings
!
®