Sampling Rate - LaserLiner ClimaData Stick Mode D'emploi

Settings

Sampling rate

Current time
Start mode
Sampling
rate
Max. points
Recording time
1 day 9 hrs. 21 min. 0 sec.
Other settings
Unit of
temperature
Unit of
Reset to
moisture
factory
settings
4.1
Current time
„Current time" shows the date and time of your computer.
4.2 Start mode
Measurement can be started manually or directly.
Manual:
Direct:
4.3
Sampling rate
The sampling rate defines how often measurements are recorded. Setting
options: 2 ... 30 seconds, 1 / 5 / 15 / 30 minutes and 1 / 5 / 12 / 24 hours.
„Max. points" shows the maximum number of measurements. The maximum
measurement duration is calculated under „Recording time". The measurement
memory is full at the end of this time.
14
EN
Real time
Manual Direct
LED cycle
Device name
Reset
Measurement is started by briefly pressing button (5).
LED (2) double-flashing indicates that measurement has
not yet started.
Measurement starts after the settings have been saved.
LED (2) flashes green every 10 seconds.
Activate high and low alarm
Temperature
High alarm
Low alarm
Humidity
High alarm
Low alarm
Configure Cancel
Save
settings
Close Setup menu
without saving