Connecting The Water Supply; Electrical Connections - GE ZBD9900RII Instructions D'installation

CONNECTING THE WATER SUPPLY

In order to prevent heat damage to the inlet valve, all solder
connections must be made before the water supply line is
connected.
Flush the water supply line prior to connecting it to the water
switch.
minute must be able to pass through the line. The water pres-
sure should be 4.2-140 psi.
(1) Water supply
(2) Water supply valve (not supplied)
NOTE:
TESTING FOR LEAKS
1. Turn on the water supply and check for leaks.
2. Turn the power on at breaker/fuse box and test the
dishwasher operation by running a Rinse cycle. (This should
take about four minutes.)
dishwasher and sink.
4. Make sure that no kinks have developed in the drain lines.
If there are no leaks and the dishwasher seems to be working
properly, continue with the installation.

ELECTRICAL CONNECTIONS

WARNING:
Before working on wiring for any electrical appliance, be sure
box.
ADVERTENCIA:
Antes de comenzar a trabajar con el cableado de cualquier
aparato eléctrico, asegúrese de haber desconectado la en-
ergía desde el interruptor/caja de fusibles.
WARNING:
Disconnect electrical power supply and place a tag at the dis-
connect switch indicating that you are working on the circuit.
ADVERTENCIA:
Desconecte el suministro de energía eléctrica y coloque una
etiqueta en el interruptor de desconexión indicando que usted
se encuentra trabajando en el circuito.
WARNING:
Electrical and grounding connections must comply with the
applicable portions of the national electrical code and/or other
local electrical codes.
ADVERTENCIA:
Las conexiones eléctricas y a tierra deben cumplir con las
partes aplicables del código eléctrico nacional y/u otros códi-
gos eléctricos locales.
The dishwasher comes with an electrical cord for 120 volts, 15
amp supplied. This cord should be plugged into the 120 volt
outlet under the sink.
If the cord is not long enough, or if a hard-wire installation is
needed, follow instructions on page 10).
GROUNDING INSTRUCTIONS
T
his unit must be grounded to operate properly. It must be
connected to a grounded metal, permanent wiring system,
or an equipment-grounding conductor must be run with the
circuit conductors and connected to the equipment-grounding
terminal or lead of the appliance.
Damage to the dishwasher could occur if it is not properly
grounded.
Electrical Requirements
connected to an individual properly grounded branch circuit
protected by a 15- or 20-ampere circuit breaker or time-
delay fuse.
(176°F).
requirements, call a licensed electrician before proceeding.
electrician.
9