Braun 4143 Instructions page 12

English
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy the new Braun
appliance.
Please read instructions carefully and completely
before using the appliance.
Parts and Accessories
1 Measuring cap
2 Lid
3 Lid gasket
4 Pitcher (plastic)
4a Pitcher (glass)
5 Blade assembly (pitcher)
5a Blade gasket
5b Blade group (black)
5c Locking ring
6 Motor body
7 On/Off button
8 Speed selection buttons
9 Chop program
10 Smoothie program
11 Crush ice program
12 Pulse button
13 Cord storage compartment
14 Smoothie2Go attachment
14a Lid with drinking spout
14b Lid gasket
14c Cup
15 Blade assembly (Smoothie2Go attachment)
15a Blade gasket
15b Blade group (grey)
Before Use
Clean all parts before using the blender for the first
time – refer to «Care and Cleaning».
Uncoil amount of cord needed from storage
compartment (13) at the bottom of the motor body.
Pitcher (A)
Assembly
• Ensure that the blade gasket (5a) is positioned on
the inside rim of the blade group (5b).
• Carefully place the blade group into the locking
ring (5c).
• Screw the blade assembly (5) to the pitcher
(4, 4a) in a clockwise motion until it can go no
further.
Blending with the Pitcher
• Make sure the appliance is turned off.
• Position the line on the locking ring (5c) in front of
you and push the pitcher down until it is securely
locked into place. The pitcher handle should be
on the right or left side of the motor body. When
12
properly positioned, the pitcher will rest completely
on the motor body.
• Add liquid ingredients first, followed by solid
ingredients. This will ensure all ingredients are
uniformly blended and prevent unnecessary
stress on the motor. Firmly place the complete lid
(1,2,3) on top.
• Plug in the power cord.
• Turn the appliance on by pressing the On/Off
button (7).
• The On/Off button will illuminate indicating that
the appliance is in stand-by mode and all other
indicator lights will flash. To start operation select
a pre-programmed speed (refer to «Operating
Instructions»).
• Always stop the blender when adding more
ingredients. Ensure the complete lid including the
measuring cap is replaced.
• During operation, you may add liquids through
the drip hole in the measuring cap.
• When finished, press the pre-selected speed
button.
• To switch off the appliance, press the On/Off
button and unplug blender before removing the
pitcher.
Thermal Protector
The blender is equipped with a thermal protector
which protects the motor from overheating. If the
motor shuts down during the performance, unplug
the blender and let it cool down for minimum 20
minutes before continue blending.
Smoothie2Go Attachment (B)
NOTE: The Smoothie2Go must only be operated
using its special blade group (15b) and for preparing
drinks and smoothies.
When preparing protein shakes using powder and
liquids only, use the pitcher.
Assembly
• Ensure that the blade gasket is positioned on the
inside rim of the blade group (15b).
• Hold the blade group at the coupling from
underneath and place it upside down in the cup.
• Screw the locking ring (5c) to the cup (14c) in a
clockwise motion until it can go no further.
Blending with the Smoothie2Go
Attachment
• Make sure the appliance is turned off.
• Fill the cup (14c) with ingredients. Ingredients
should be added in reverse order of the regular
pitcher – solids first, then liquids.
• Carefully place the blade group including gasket
onto the cup.
• Screw the locking ring in a clockwise motion until
it can go no further.