Door Glass Replacement; Annual Maintenance - Napoleon GX70NTE Instructions D'installation Et D'utilisation

Masquer les pouces Voir aussi pour GX70NTE:

Table des Matières

Les langues disponibles

10.1

ANNUAL MAINTENANCE

THE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOL

COMPLETELY OR WEAR HEAT RESISTANT GLOVES BEFORE CONDUCTING SERVICE.

•

This appliance will require maintenance which should be planned on an annual basis.

•

Service should include cleaning, battery replacement, venting inspection and inspection of the burner,

media and fi rebox. Refer to the door removal section and remove the door as instructed.

•

Carefully remove media if necessary (logs, glass, brick panels etc).

•

Using a vacuum with a soft brush attachment, gently remove any dirt, debris or carbon build up from the

logs, fi rebox and burner. For glass media, follow the installation instructions for pre-cleaning.

•

Also gently remove any build-up on the pilot assembly including, if equipped; thermopile, thermocouple,

fl ame sensor and igniter. NOTE: Clean fl ame sensor using a fi ne emery cloth or a synthetic scrub pad

(such as Scotch-Brite™) to remove any oxides. Clean the pilot assembly using a vacuum with a soft

brush attachment. It is important that the pilot assembly is not painted.

•

Inspect all accessible gaskets and replace as required.

•

Access the blower, if equipped and clean using a soft brush and vacuum.

•

Re-assemble the various components in reverse order.

•

Inspect the relief system. The appliance relieves through the main glass door or through the fl aps on the

fi rebox top. Ensure they open freely, and close sealed.

•

Check the gas control valve pilot and Hi / Lo knobs move freely (if equipped) – replace if any stiffness in

movement is experienced.

•

Check for gas leaks on all gas connections up and downstream from the gas valve including the pilot

tube connections.

10.2