Klarstein 10009348 Mode D'emploi page 17

Menu
It is used to set different programs. Each time it is pressed (accompanied by a short beep) the program
will vary. Press the button discontinuously, the 12 menus will be cycled to show on the LCD display. Select
your desired program. The functions of 12 menus will be explained below.
1. Basic: kneading, rise and baking normal bread. You may also add ingredients to increase flavor.
2. Whole wheat: kneading, rise and baking of whole wheat bread. It is not advised to use the
delay function as this can produce poor results.
3. French: kneading, rise and baking with a longer rise time. The bread baked in this menu will
have a crisper crust and loose texture.
4. Quick: kneading, rise and baking loaf within the time less than Basic bread. But the bread baked
on this setting is usually smaller with a dense texture.
5. Sweet: kneading, rise and baking sweet bread. You may also add ingredients to add flavor.
6. Cake: kneading, rise and baking, but rise with soda or baking powder.
7. Jam: boiling jams and marmalades. Fruit or vegetables must be chopped before putting it into
the bread pan.
8. Dough: kneading and rise, but without baking. Remove the dough and use for making bread
rolls, pizza, steamed bread, etc.
9. Ultra fast: kneading, rise and baking loaf in a short time, bread with a dense texture.
10. Bake: only baking, no kneading and rise. Also used for increasing the baking time on selected
settings.
11. Dessert: kneading, rise and baking dessert.
12. Home made: Can self-program by customer, to reset kneading, rise, baking, keep warm every
step time.
The time range of each program as following:
KNEAD1: 6-14 minutes
RISE1: 20-60 minutes
KNEAD2: 5-20 minutes
RISE2: 5-120 minutes
RISE3: 0-120 minutes
BAKE: 0-80 minutes
KEEP WARM: 0-60 minutes
Under the menu of Home Made,
a. Press CYCLE button once, KNEAD1 will appear on LCD, then press TIME button to adjust the
minutes, and press CYCLE to confirm the time for this step;
b. Press CYCLE to enter the next step, RISE1 will appear on LCD, and then press TIME button to
adjust the minutes, the number will increase rapidly if TIME button is holding. Further press
CYCLE to confirm.
c. In this way set the remaining steps. Upon finishing setting for all steps, press Start/stop button
to exit the setting.
d. Press Start/stop button further to activate the operation.
Note: the setting can be memorized and is effective in next use.
17