Repair And Maintenance; Adjusting The Brakes - Razor E100 Série Manuel Du Propriétaire

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off

Adjusting the Brakes

Tools required: 10 mm wrench
1
To adjust brake cable play, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
Replacing the Front Wheel
Tools required: 10 mm wrench and two (2) 16 mm wrenches
1
Using a 10 mm wrench loosen
the brake cable bolt.
Replacing the Chain and Rear Wheel
Tools required: Phillips screwdriver and two (2) 13 mm wrenches
1
Using a Phillips screwdriver,
loosen the two (2) screws on the
chain guard and remove.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
If brake is too tight or has too
much slack, use a 10 mm wrench
to loosen the brake cable and
adjust accordingly.
2
Using two (2) 16 mm wrenches,
loosen the locknuts by turning
the wrenches counter clockwise.
Remove wheel and install
replacement wheel. Reference front
wheel hardware sequence on this
page.
2
Using two (2) 13 mm wrenches,
loosen the locknuts by turning
the wrenches counter clockwise.
Reference rear wheel hardware
sequence (page 7).
• Contact Razor customer service
if unsure about any repair or
maintenance
3
Inspect the brake pads (A)
for proper alignment against the
wheel or excess wear. To realign
brake pads, loosen the fixing nut
(B) and adjust the pad to contact
the rim. Re-tighten and readjust
as needed. Verify proper brake
function prior to riding the scooter.
3
Reassemble, adjust and
tighten brake cable. Verify
proper brake function prior to
riding the scooter.
3
To loosen the chain, pushing
the tensioner down to create
some slack in the chain.
6
Note: Front wheel hardware
sequence
8-3
8-2
8-6
8-7
8-5
8-2
8-1
8-2
8-2
Right Side (Throttle)
8-3 Spacer
8-2 Washer
Fork
8-2 Washer
8-7 Spring Washer
8-1 16 mm Locknut
Middle
8-6 Front Axle Bolt
Left Side (Brake)
8-5 Spacer
8-2 Washer
Fork
8-2 Washer
8-7 Spring Washer
8-1 16 mm Locknut
8-1
8-7