Instruction Sheet - 3B SCIENTIFIC PHYSICS U104001 Instructions D'utilisation

Appareil d'analyse du point critique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
3B SCIENTIFIC ® PHYSICS

Instruction sheet

09/10 MH/JS
20
21
19
18
17
16
15
14
On delivery, the critical point apparatus is filled with
hydraulic fluid. The test gas is not included.
Before filling with the test gas, carry out a volume
calibration, as described in chapter 6, using air as an
approximation of an ideal gas.
Filling with the test gas is described in chapter 7.
Experimental investigations are described in chap-
ter 8.
Important notes on storage of the test gas and
equipment (if not in use for a long period) are stated
in chapter 9.
Critical Point Apparatus U104001
23
22
1 2
13
12
11
9
8
1. Contents of instruction manual
1
2
3
4
5
6
7
8
9
10 Outlet for thermal medium
11 Inlet for thermal medium
12 End plate
13 Cylinder
14 Conical seal
3 4
15 Measuring cell
16 Valve plate
17 Regulating valve
18 Gas connection fittings 1/8"
19 Flush valve
20 Hole for thermocouple
5
21 Heat casing
22 Safety valve
23 Manometer (excess pressure indicator)
7
6
Owing to the inevitable diffusion of the test gas
through the conical seal, it is necessary to degas the
hydraulic fluid in the equipment, as described in
chapter 10. This must be done before the equipment
is put away for storage (after removing the test gas) or
if it has been in use for a long time.
The threaded bush in the frame must be lubricated
regularly and also inspected at lengthier intervals.
Refer to section 11 for instructions.
Maintenance work as described in chapter 12 is only
required if the rubber components get worn out and
their functionality is adversely affected.
1
Vernier scale
Fixed scale
Grease nipple
Threaded bush
Handwheel
Base
Frame
Threaded axle with piston
Piston cover
(for Minican® gas container)

Publicité

Table des Matières
loading

Table des Matières