Troubleshooting Guide - Hamilton Beach Commercial Rio Série Manuel D'utilisation

Caring for the Blender
Replacing the Cutter Unit Assembly
wWARNING
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other utensils
in container when blending.
Failure to follow these instructions can result
in broken bones, cuts, or other injuries.
Replacing the cutter unit assembly
The cutter unit assembly should be checked daily
for worn, loose, or damaged blades. If the cutter
unit assembly is worn or damaged, it should be
replaced immediately.
1. Position a flat bladed screwdriver against one
of the clutch teeth. Holding the nut inside the
container with a socket, tap the screwdriver so
that the clutch rotates in a counterclockwise
direction. After a few taps, it should be possible
to remove the clutch by hand.
2. Loosen the jam nut and retainer nut on the
bottom of the container.
3. From the bottom of the container, press the
cutter unit assembly up into the container and
remove it. CAUTION—Blades are sharp!

Troubleshooting Guide

Problem . . .
Blender fails to start or
stops while it is running
and cannot be restarted
Ingredients will not mix
properly
8
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a
circuit breaker has tripped.
• Check to see if enough liquid has been added to the ingredients. Mixture
should be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" (2.5 cm) cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and
cutter assembly daily. Replace the cutter assembly at least every 90 days
or sooner if cutter assembly appears worn or damaged.
• Check to see if cutter unit assembly is installed properly.
• Select speed to create a fluid blend.
4. Install the new cutter assembly and tighten the
retainer nut SECURELY, but do not overtighten.
Tighten the jam nut on top of the retainer nut.
5. Reinstall the clutch onto the cutter unit.
Cutter Unit
Assembly
Retainer
Nut
Jam Nut
Clutch