MVP AXIS AX-CL06M CL06D Mode D'emploi page 8

ELECTRICAL CONNECTION – VALID FOR LIDO/GIUDECCA OVENS
ATTENTION
All electrical connections must be carried out by qualified and authorised
personnel, in compliance with the laws in force.
Operations carried out incorrectly may cause damages and injuries
(including serious ones) to people, animals and/or property.
Read this instruction manual carefully and fully understand the information
contained in it prior to carrying out the installation.
The power supply must comply with the voltage and frequency specified in the
technical data plate.
The technical data label indicated information useful for wiring the appliance;
consequently, it must not be removed, ruined or altered in any way.
The appliance must be connected to an earthing system, in compliance local
regulations in force.
In the absence of regulations governing the earthing of the device, please refer
to the "National Electrical Code ANSI/NFPA No.70".
In Canada, all electrical connections must be performed according to
standards CSA C22.1
ATTENTION
To prevent any damages (including serious ones) to people, animals and/or
property, unplug the appliance from the mains prior to carrying out any type of
maintenance, installation and/or cleaning operations.
The terminal strip is positioned on the right side of the appliance (looking at it from the front).
To access the terminal strip, you need to remove the side panel of the oven, unscrewing the 2
screws located in the oven base (directly underneath the side panel).
If necessary, also remove the back panel of the oven to facilitate the wiring operations, by
unscrewing the self-threading screws the secure this panel.
On the rear panel of the oven, there is a wiring label you can refer to, since it illustrates the proper
wiring to be carried out on the terminal strip.
Carefully follow the wiring instructions provided on the label.
Prior to using the oven, make sure that all cables and connectors are properly secured, since they
can become loose during transport.
After having completed all the connections (electrical and water), check once again the proper
fixing of all electrical connections.