Extraordinary Maintenance - MVP AXIS AX-CL06M CL06D Mode D'emploi

REPLACING THE LIGHT BULB - CONVECTION OVENS
ATTENTION: Strictly adhere to the following procedure in order to avoid electrocution or damage to
people:
•
Disconnect the oven from the electrical supply
and let it cool down.
•
Remove the side supports that
hold the baking trays.
• Unscrew the glass cover "A", being careful not
to damage the gasket "C".
• Replace the lamp "B" with one having the same
characteristics.
• Screw the glass cover "A" back on, being
careful not to damage the gasket "C".

EXTRAORDINARY MAINTENANCE

It is advisable to have the appliance subjected to periodical checks (at least once per year) by a
specialist, authorised technician.
Any maintenance, installation or repair work must be carried out by qualified, authorised personnel
by contacting the Customer Service.
Before carrying out any operation, the appliance must be disconnected from the mains power
supply, turn off the water supply and wait for the appliance to cool down.
Before moving the appliance from its position, check that the electricity and water connections
(electric cables, water pipe and drainage) have been properly disconnected.
If the appliance is on wheels check that the electric cables, pipes or anything else are not
damaged while moving it.
Ensure the brake is on. Avoid placing the oven near heat sources (such as fryers, etc.). After
carrying out the task and returning the appliance to its initial position, check that the electric and
water supplies are connected correctly.
MAINTENANCE IN CASE OF BREAKAGE
If the appliance breaks, disconnect it from the mains power supply and turn off the water.
Before ringing the Customer Service, check the chart below.
FAULT CAUSE
Door open
In START mode
he oven does
The micro-switch does not signal that
not turn on
the door is closed
Loose lamp
Oven light off
Blown lamp
The fans no longer execute inversion
The oven does
not cook
One of the fans has stopped
uniformly
One of the heating elements is broken
No power supply
The oven is
Incorrect connection to the mains power supply
completely off
Safety thermostat triggered
SOLUTION
Make sure the door is closed
Contact a specialist technician for repairs
(Customer Service).
Insert the lamp correctly into the lamp holder
Replace the lamp (refer to ordinary maintenance)
Contact a specialist technician for repairs
(Customer Service).
Contact a specialist technician for repairs
(Customer Service).
Contact a specialist technician for repairs
(Customer Service).
Restore the power supply
Check connection to the mains power supply
Contact a specialist technician for repairs
(Customer Service).