Cause Possible - Radiatori 2000 PIANO II 600/3 Guide Rapide

Activate the Stand-by mode, press the CHRONO key for more than 5 seconds, scroll through
the modes with the [+] key and select FUNC with the PROG key, press it until the icon appears
at the top of the screen. Then select ON with the [+] key and press PROG again to confirm.
After a few seconds, the remote control automatically returns to Stand-by mode.
ECO FUNCTION
This mode allows you to limit power consumption by lowering the set comfort temperature
by 3 degrees. By activating this mode, the device operates while maintaining a temperature
corresponding to: SET TEMPERATURE - 3 ° C.
Activate the Stand-by mode, press the CHRONO key for more than 5 seconds, scroll through
the modes with the [+] key, select FUNC with the PROG key and press it until the icon appe-
ars; Select ON with the [+] key and press PROG again to confirm. After a few seconds, the
remote control automatically returns to Stand-by mode.
KEYPAD LOCKED
This function allows the user to lock the keypad to prevent accidental changes.
All buttons on the remote control are locked. To activate the lock function, press PROG for 5
seconds.
To deactivate the function, repeat the procedure.
IMPORTANT: THE REMOTE CONTROL AND THE APPLICATION ARE MUTUALLY EXCLUSIVE
AND CANNOT BE SIMULTANEOUSLY CONNECTED TO THE SAME THERMOSTAT
Problème
The radiator
does not
heat up
TROUBLESHOOTING

Cause possible

A low temperature is
set, or is very close to
the room temperature
The temperature
sensor is covered
Solution
Check operation of the
radiator by adjusting
comfort mode to a
temperature of 25°C.
Check that the bottom
of the radiator is not
covered and is at least
20 cm off the ground.
39