Radiatori 2000 PIANO II 600/3 Guide Rapide page 38

ANTIFREEZE
In "Antifreeze" mode, the temperature is set at 7 ° C. The device activates the heating element
when the ambient temperature drops below 7 ° C. It is recommended to use this mode when
the room is not used for several days. Press the [Prog] key until the "Antifreeze" icon appears
on the display.
BOOST 2H
The "BOOSTH 2h" mode allows you to quickly heat the room or speed up the drying of
towels.
- Press the [Prog] key until the "2h" icon appears on the screen.
The appliance is turned on at maximum power for 2 hours, with a temperature set at 30 ° C.
The "Boost 2h" mode is set to stop automatically after a period of 2 hours and return to the
previously set operating mode. If necessary, the user can return to other modes at any time
by simply pressing the [Prog] key.
FIL-PILOTE
It is possible to connect the thermostat to a Fil-Pilote control unit.
NOTE: this connection is only possible for Class II models supplied without plug.
CHRONO - PROGRAM MODE
a) Set the current day and time following the steps below:
- Activate the "Stand-by" mode and press the [Chrono] key for more than 3 seconds.
- The screen will display the words: "Time";
- Press the [Prog] key to enter the mode;
- Set the current year with the [+] and [-] keys;
- Press the [Prog] key again to confirm;
- Set the current month with the [+] and [-] keys;
- Press the [Prog] key again to confirm;
- Set the current day with the [+] and [-] keys;
- Press the [Prog] key again to confirm;
- The display now shows the current time to be confirmed;
- 'Hours': use the [+] and [-] keys to set the hour and confirm with the [Prog] key;
- 'Minutes': repeat the same procedure and confirm with the [Prog] key;
- Finally, the thermostat returns to "Stand-by" mode;
ATTENTION: if the current day and time are not set before programming the thermostat, the
programming of the weekly time bands will not be correct.
b) Set the program for Chrono mode:
- Access "Stand-by" mode and press the [Chrono] key for more than 3 seconds.
- At the top of the screen you will see the words: "Time".
c) To use a predefined mode or to use one of the two programmable modes (Pr8 and Pr9),
press the [Stand-By / ON] key and exit the stand-by mode, press the [Prog] key until what
the screen displays the symbol is displayed.
The program used is displayed in the upper part of the screen (from P1 to P9), the programs
are selected by pressing the [Chrono] key, in the external part of the screen it is possible to
see the command bars of the indicated program time.
The diagrams of the 7 predefined programs are shown:
37