Radiatori 2000 PIANO II 600/3 Guide Rapide page 37

5) RESET
Delete all stored fixed units and reset the remote control to factory settings:
STAND-BY ----> CHRONO x 5 sec ----> select with + & - RSET on the screen ----- -> PROG.
The message RSET will flash on the screen. At this point, press again the button PROG to
confirm . Reset or press the button ON / OFF (or wait) to cancel. The thermostat returns to
wait the first connection.
6) BATTERY ICON
When the batteries are low, the battery icon will light up. The remote control can still be used,
but it is best to use new batteries. When the battery power is low, the word "BATT" will be
displayed on the remote control and will stop working until the batteries are turned off or
replaced.
SPECIFICATION OF FUNCTIONS WITH THE REMOTE CONTROL
STAND-BY
Press the ON / Stand-by button to turn on the device or activate "Stand-by" mode.
When the unit is active, the setting mode and temperature are displayed.
During the "Stand-by" state, the display shows the ON / OFF symbol, the current time and the
day of the week. NOTE: when the device goes into "Stand-by" mode, 2 beeps of 0.5 seconds are
emitted. When the device is on, it emits two beeps lasting one second.
COMFORT / NIGHT REDUCTION
Two different temperature levels can be set:
TEMPERATURE "COMFORT": this is the temperature used for the "Crono", "Fil-Pilote" and
"Comfort" modes.
TEMPERATURE "NIGHT": this is the temperature used for the "Night", "Chrono" and "Fil-Pilote"
modes. The desired temperature setting can be adjusted by pressing the [+] and [-] buttons.
The temperature adjustment range is between 7 ° C et 30 ° C.
IMPORTANT! The "Night" temperature is always lower than the "Comfort" temperature and
priority is given to the "Comfort" temperature. For this reason, the "Night" temperature can be
set in the range 7 ° C ÷ (selected comfort temperature), the "comfort" temperature can be set
over the whole range: 7 to 30 ° C.
The "Comfort" mode allows you to maintain the set room temperature.
To adjust this mode: Press the [Prog] key until the "Comfort" mode icon appears on the screen.
Set the desired temperature with the [+] and [-] buttons.
In "Night" mode, a temperature lower than the "Comfort" temperature is set. It is recommended
to use this mode at night or when the room is not used for 2 hours or more.
Press the [Prog] key until the "Night" icon appears on the display. Set the desired temperature
with the [+] and [-] buttons.
36