Remote Control - Radiatori 2000 PIANO II 600/3 Guide Rapide

REMOTE CONTROL

As an alternative to the application, the electronics also communicate with a remote remote
control which can be purchased on request.
The remote control has a wireless connection: it can be portable or docked to the mur near the
radiator (maximum distance: 4 meters).
Utilizzando il telecomando remoto, è possibile controllare il termostato SMART con le
stesse modalità operative: Stand-by, Fil Pilot, Comfort, Riduzione notturna, Antigelo,
Termostato programmabile, BOOST 2H, ECO, rilevatore di finestre aperte, ASC.
For more information and detailed instructions, see the website.
PAIRING TO THE REMOTE CONTROL
Press the ON / Stand-by button to turn on the device or activate "Stand-by" mode.
When the unit is active, the setting mode and temperature are displayed.
1) FIRST USE AND PAIRING WITH THE REMOTE CONTROL
When no device is paired, the remote display will show the word "Conn" as long as at least one
thermostat is paired.
2) CONNECTION TO THE FIRST DEVICE
While the word "Conn" is still on the screen, approach the stationary unit and press the Pairing
button on the chronothermostat, then press the [PROG] button on the remote control.
The search symbol appears on the screen until the thermostat is found, or 10 seconds elapse.
If during this time the thermostat is not identified, repeat the operation bringing the two
devices together and making sure that the steps are correctly followed.
3) CONNECTION TO OTHER DEVICES
STAND-BY ----> CHRONO: to make the association, you must be in Stand-by and press the
Chrono button for 5 seconds.
Select with + & - PAIR on the remote control screen, then press the PROG button.
By following the previous steps, you access the ''Conn'' screen (see previous paragraph).
In this case, if you already have 8 units in memory, by pressing ON / OFF you can exit the
"Conn" screen; if there are already 8 fixed units in the memory, you will be asked which one to
delete and replace with the new unit (for the complete elimination of the selected thermostat,
the new connection must be successful).
4) CHANGE THE FIXED UNIT (THERMOSTAT) TO MANAGE
The remote control only uses one fixed unit at a time. To select another fixed reader:
- From STAND-BY: press [Chrono] for 5 sec -----> Select SLCT with [+] & [-] and press [Prog]
to confirm.
- From another operative mode: Press [Chrono] for 5 sec ------> select the number of the
device X with [+] & [-] ------> press [Prog] to confirm.
[Fig. 17]
www.ridea.it
or write to
customerservice@radiatori2000.it
35