Package Contents; Description (Fig. A); Assembly And Adjustment - DeWalt DW071 Mode D'emploi

E N G L I S H

Package contents

The package contains:
1 Rotary laser
1 Wall mount/base
1 Target card
1 Pair of glasses
3 LR14 (D) batteries
1 Kitbox
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

The rotary laser DW071 has been designed to
project laser lines to aid in professional applications.
The tool can be used both inside and outside for
horizontal (level) and vertical (plumb) alignment.
The tool can also produce a stationary laser dot that
can be directed manually to establish or transfer a
mark. The applications range from drop-ceiling
installation and wall layout to foundation leveling and
deck building.
1 Variable speed switch
2 Bump sensor reset button
3 Bump sensor activation button
4 Carrying handle
5 Leveling knob
6 Wall mount
7 Laser head rotation button
8 Rotary laser head
9 Front air level
10 Front level adjustment knob
11 Wall mount clamp
12 Wall mount clamp lock
13 Rack pinion wheel
14 Fitting knob
15 Battery compartment
16 Rack pinion locking knob
17 Side level adjustment knob
18 Side air level

Assembly and adjustment

Replacing batteries (fig. B)
The attachment uses batteries of type LR14 (D).
• Unscrew and remove the battery compartment
cover (19).
30
• Replace the batteries (20). Make sure the new
batteries are placed as indicated (21).
• Re-install the battery compartment cover.
When replacing batteries, always replace
the complete set. Do not mix old
batteries with new ones. Preferably use
alkaline batteries.
Low battery indicator (fig. B)
The tool has been equipped with a low battery
indicator (22) located on the control panel. The low
battery indicator is lit while the tool is switched on.
It will blink to indicate that the batteries need to be
replaced and the tool will automatically shut down.
• Switch off the tool and remove the batteries as
soon as the indicator blinks.
Setting up the tool (fig. C1 - C5)
The tool facilitates various set-ups, making it useful
for several applications.
Mounting the tool to the wall mount (fig. C1)
The wall mount may also be used as a base to
provide extra stability for the tool.
• Place the tool onto the wall mount as required for
your application.
• Fit the tool to the wall mount by inserting the
threaded pin (23) into one of the receptacles in
the tool and tightening the knob (14).
Floor set-up (fig. C1)
• Place the tool on a relatively smooth and level
surface.
• Adjust the tool for a level or plumb application.
Wall set-up (fig. C2 - C5)
The tool is equipped with a wall mount (11) for
mounting to a wall track to aid in drop ceiling
installation and other specialty leveling projects
(fig. C2).
• Mount the tool to the wall mount as described
above.
• Turn the tool on its side with the wall mount
clamp (11) in position for attachment to the wall
track (fig. C3).
• With the wall mount (6) facing the wall, turn the
wall mount clamping lock (12) in the clockwise
direction to open the clamp jaws.