U.S.Robotics 5661A Mode D'emploi page 8

2. Next, make sure that the drivers have been installed correctly. Follow the instructions for
your operating system:
Windows 95/98/Me
Click Windows Start, Settings, and then Control Panel. Double-click the System icon. Click the
the Device Manager tab. Click to expand HSFMODEM. You should see U.S. Robotics V.92 PCI
Modem Enumerator listed. Click to expand Modem or Modems. You should see U.S. Robotics
V.92 PCI Modem listed. This means that the installation was a success. If your modem is not
listed, shut down and restart your computer. If it is still not listed, go to the next Troubleshooting
category in this guide, "My computer isn't recognising my modem," or uninstall your modem and
reinstall it.
Windows 2000
Click Windows Start, Settings, and then Control Panel. Double-click System. Click the Hardware
tab and then the Device Manager button. Click to expand Modems. You should see U.S. Robotics
V.92 PCI Modem listed. This means that the installation was a success. If your modem is not
listed, shut down and restart your computer. If it is still not listed, go to the next Troubleshooting
category in this guide, "My computer isn't recognising my modem," or uninstall your modem and
reinstall it.
Windows XP
Click Windows Start and then Control Panel. Double-click System. If you do not see the System
icon, make sure you are in Classic View. Click Switch to Classic View on the upper left side of the
window. Click the Hardware tab and then the Device Manager button. Click to expand Modems.
You should see U.S. Robotics V.92 PCI Modem listed. This means that the installation was a
success. If your modem is not listed, shut down and restart your computer. If it is still not listed,
go to the next Troubleshooting category in this guide, "My computer isn't recognising my
modem," or uninstall your modem and reinstall it.
My computer isn't recognising my modem.
If Plug and Play fails to find the modem as new hardware, you need to check the following:
• With your computer turned off, confirm that the modem is firmly seated in the PCI slot. The
modem should sit evenly in the slot with no part of the gold edge showing.
• With your computer turned off, try installing the modem in another PCI slot.
• Check your computer manual to make sure that the PCI slot is configured properly.
My modem seemed to install correctly but doesn't work or is performing
erratically.
Possible solution:
Hardware resources are not properly assigned to your modem. Although PCI devices can share
IRQs, there are devices on the market which do not share IRQs properly. If the modem has been
assigned to an IRQ with one of these devices, the modem may perform erratically.
Windows 95/98/Me
Right-click the My Computer icon on your desktop. Click Properties and then click the Device
Manager tab. In the list of devices, double-click the Modem or Modems category. Look for your
7