U.S.Robotics 5661A Mode D'emploi page 30

Installation Instructions
Prepare for installation.
CAUTION: To avoid the risk of electrical shock, make sure your computer and all
peripheral devices are turned off and unplugged. Disconnect all telephone cables from
any existing modems before opening the computer's cover. Touch an unpainted metal
area of your computer's case to ground yourself, which protects your equipment from
electrostatic discharge.
NOTE: U.S. Robotics recommends uninstalling any other modems that are installed in
your system and unplugging all telephone cords connected to these modems. Refer to
your previous modem's documentation for instructions.
Write your new U.S. Robotics modem's serial number in the box below. The serial number is
located on the white bar code sticker on the modem and on the modem's box. If you ever need to
call our Technical Support department, you will need this number, your Product ID Number, and
your Model Number to receive assistance.
Product ID Number Model Number
USR805661A
Step 1: Physically install the modem in your computer.
Turn off your computer and all peripheral devices.
Unplug your computer and remove the computer's
cover. Remove the expansion slot cover at the back of
an empty PCI expansion slot. PCI slots are usually
white in color. The slot cover is on the back of your
computer and covers an opening on your computer's
case. The slot cover could be held in place with a screw
or a clip.
Insert the modem into the PCI slot. You may need to
rock the modem back and forth while pressing down
firmly to properly seat the modem in the PCI slot.
The modem's metal bracket will cover the opening on
the back of the computer. If applicable, secure the modem with the screw or clip you removed.
Replace the computer's cover.
Step 2: Connect the modem to an analogue phone line.
Plug one end of the provided phone cord into the jack on the modem labeled
end into an analogue phone wall jack.
Serial Number
5661
2
. Plug the other