Yakima SpareRide Mode D'emploi page 3

INSTALL SPARE TIRE
It is very important that
you follow your vehicle's
owner's manual carefully
to properly replace the
spare tire.
INSTALL SPARERIDE
Place your
SpareRide onto
the protruding
mounting bracket
tongue.
Optional Lock Loop installation.
If you would like
to use the Lock
Loop to lock your
bikes to, install
it now. It can
be installed as
shown, or rotated
180° so the loop
points downward.
Instruction #1035694B - Page 3 of 18
Thread the
locking knob
through hole
in SpareRide
mast, and into
the mounting
bracket.
LOCK LOOP
Tighten locking
WASHER
knob completely.
Use the key to lock the knob. This helps
protects your SpareRide from theft.
NOTE: When knob is locked the
knob will turn, however, it is
disengaged and cannot tighten, or
loosen the SpareRide. Therefore to
tighten or loosen the knob it must
be in the unlocked position.