Safety Instructions - aldes VMC Dee Fly Hygro Notice De Montage

Motor casing construction
• Steel casing
• Trim in expanded polypropylene
• Microwatt motors: Two 3-speed EC motors on ball bearings
with thermal protection
Heat exchanger casing construction
• Expanded polypropylene casing
• High efficiency heat exchanger with counter current system
• 1 extraction G4 filter
• 1 air supply F7 filter
Aeraulic connection
• Motorisation: 4 Ø 160 mm connectors
• Exchanger: 4 Ø 160 mm connectors

SAFETY INSTRUCTIONS

Assembly precautions
• 230V–50Hz single-phase power supply
• Connections to the electrical mains should be
fitted by a qualified professional in accord-
ance with the rules laid down in NF C 15-100
Disconnect the electrical
supply before any or in compliance with applicable regulations in
operations and ensure that
the country of installation. A contact-breaking
the unit cannot be started
device with a separation of at least 3 mm should
accidentally.
be used on each pole.
• The electrical connections must use flexible
cabling which must have a cross section at least
equal to that of H05VV-F or H05RR-F.
• If the supply cable is damaged it must be
replaced, by a professional, with a cable of the
Never operate on the same reference, respecting the rules of NF C
electrical unit when the
15-100.
unit is running
The HRV system must run 24 hours a day.
Renews air
•
Eliminates bad smells
•
Evacuates humidity
•
Contributes to hygiene and comfort
23
Field of Use
The Dee Fly system is suitable for up to 7 'humid' rooms
(any room fitted with a water supply – excluding the kitchen),
with a minimum of 1 bathroom and 1 WC.
Operating temperature limits
Temperature of installation premises: 0°C/50°C. For optimum
output, the heat exchanger must be placed in a heated space.
Exhaust and fresh air temperature: -7°C/45°C
Power supply
230V – 50 Hz single-phased
Electrical protection
2A (10A if offset electrical heating coil accessory)
Precautions prior to starting up
• When starting up, all duct work, including
exhausts and fresh air inlets, must be
connected.
• Never place your hands in front of an inlet or
outlet orifice.
Installation precautions
• If installing in a dwelling with an open hearth fire
emplacement, a wood burning stove or similar
heating appliance, refer to the applicable
regulations in the country of installation.