Troubleshooting Table - Poulan Pro PR 2322 Manuel D'instructions

TROUBLESHOOTING TABLE

a WARNING: Always stop unit and disconnect spark plug before performing all of the recommended
remedies below except remedies that require operation of the unit.
TROUBLE
Engine will not start.
Engine will not idle properly.
Engine will not accelerate, lacks
power, or dies under a load.
Engine smokes excessively.
Engine runs hot.
8
TROUBLESHOOTING
CAUSE
1. ON/OFF switch in the OFF
position.
2.
3. Fuel tank empty.
4.
5. Fuel not reaching carburetor.
6. Compression low.
1.
adjustment.
2. Crankshaft seals worn.
3. Compression low.
1.
2. Spark plug fouled.
3.
adjustment.
4.
outlet screen.
5. Compression low.
1. Choke partially on.
2. Fuel mixture incorrect.
3.
4.
adjustment.
1. Fuel mixture incorrect.
2. Spark plug incorrect.
3.
adjustment.
4.
outlet screen.
REMEDY
1. Move ON/OFF switch to the ON
position.
2. See "Starting a Flooded Engine" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5.
Check for kinked or split fuel line;
repair or replace.
6. Contact an authorized service dealer.
1. See "Carburetor Idle Speed
Adjustment" in Service and
Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1.
2. Clean or replace plug and regap.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
1. Adjust choke.
2.
fuel mixture.
3.
4. Contact an authorized service dealer.
1. See "Fueling the Engine" in Operation
section.
2. Replace with correct spark plug.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.