Troubleshooting - Haier HW120-B14686-F Mode D'emploi

Troubleshooting

C o d e C a u e s
Unb Unbalanced load - error.
* Warning!
Code Fb: Water-overflow protection
all functions will be shut down automatically except drain pump which will be activated for safety
reasons.
Troubleshooting without display code
P o r b e l m
Washing machine fails
to operate.
Washing machine
will not be filled with
water.
Machine is draining
while being filled
Drainage failure
Strong vibration while
spinning
(1)
is placed on deepest part of appliance. In case of leackage
C a u e s
Programme is not yet started.
Door is not properly closed.
Machine has not been switched on
Power failure.
No water.
Inlet hose is kniked.
Inlet hose filter is blocked.
Water pressure is less than
0,03 MPa.
Door is not properly closed
Water supply failure
Height of drain hose is below
80 cm.
Drain hose end could reach into
water.
Drain hose is blocked
Pump filter is blocked
Drain hose end is higher than
100 cm abovefioor level
Not all transportation bolts have
been removed.
Appliance has no solid position.
Machine load is not correct.
S l o t u o i n
Check and balance laundry load in the drum.
Reduce the load.
S l o t u
Check programme and start it.
Close the door properly.
Switch the machine on.
Check power supply.
Check water
Check inlet hose.
Unblock inlet hose filter.
Check water pressure.
Close the door properly.
Ensure the water supply
Make sure that drain hose is
properly installed.
Make sure the drain hose is
not in water
Unblock drain hose.
Clean pump filter.
Make sure that drain hose is
properly installed
Remove all transportation
bolts.
Ensure solid ground and a
evelled position.
Check load weight and balance.
(1): optional
o i n
tap.
21