Troubleshooting; In Case Of Power Failure - Haier HW80-B14266 Mode D'emploi

Troubleshooting

In case of power failure

lever
The current programme and its setting will be saved. When
power supply is restored operation will be resumed. To can-
cel it, touch "Start/Pause" and then "Power" for about 3 sec.
If a power failure cuts an operating wash programme door
opening is mechanically blocked. To get out any laundry water
level should not be seen in the glassy porthole of the door. -
Danger of burns! Water level has to be lowered as described
in "Pump filter". Not till then pull lever beneath service flap
until door is unlocked by a gentle click. Afterwards refix all
parts.
Troubleshooting without display code
Problem Cause
Washing machine Power failure.
fails to operate. Machine has not been switched on. Switch the machine on.
Door is not properly closed.
Programme is not yet started.
Washing machine No chosen programme.
will not be filled
with water.
Inlet hose is kniked.
Inlet hose filter is blocked.
Water pressure is less than
0,03 MPa.
Water supply failure.
Door is not properly closed.
Machine is draining Height of drain hose is
while being filled below 80 cm.
Drain hose end could
reach into water.
20
Solution
Check power supply.
Close the door properly.
Press "Start/Pause" button.
Set programme and start it.
Water tap is closed. Turn
on water tap.
Check inlet hose.
Unblock inlet hose filter.
Check water pressure.
Ensure the water supply.
Close door properly.
Make sure that drain hose
is properly installed.
21
Problem Cause
Drainage failure Drain hose is blocked.
Drain hose end is higher than
100 cm above floor level.
Pump filter is blocked.
Strong vibration Not all transportation bolts
while spinning have been removed.
Washing machine is located
on an uneven surface or is
not levelled.
Machine load is not correct..
Operation stops Water or electric failure.
before completing
wash cycle
Operation stops Appliance displays error code.
for a period of time Problem due to load pattern.
Programme performs
soaking cycle?
Excessive foam Detergent is not a appropriate.
floats drum and/or
detergent drawer Excessive use of detergent.
Automatic adjustment Washing programme
of washing time duration will be adjusted.
Spinning fails Unbalance of laundry.
General information and tips:
If too much foam is inspected during spin cycle, motor stops and drain pump will be
activated for 90 seconds. If that elimination of foam fails up to 3 times, programme
ends without spinning.
Troubleshooting
Solution
Unblock drain hose.
Make sure that drain hose
is properly installed.
Clean pump filter.
Remove all transportation
bolts.
Make sure that washing
machine is on an even sur-
face and levelled.
Adapt amount of laundry.
Check power
and water supply.
Consider error code.
If it seems appropriate
cancel operation.
Check detergent
recommendations.
Reduce amount of detergent
This is normal and doesn't
affect functionality.
Check machine load and
laundry and run a spinning
programme again.