Power Supply Connection - Haier HW120-B14686-F Mode D'emploi

Installation
Inlet hose - Aqua control System
The Aqua Stop inlet hose is an important element for
safety and over all control. Its valves are controlling water
supply and will interrupt it if the hose is leaking
1. Connect the nut on the inlet hose to the connector
on the water valve.
2. Apply inlet hose to a water tap.
Do not twist, kink or jam the inlet hose.
Warning!
Appliance is only qualified for cold water supply!
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
Do not connect to hot water.

Power supply connection

Before each connection check if:
the power supply, the socket and fusing is
appropriate to the rating plate.
the power socket is earthed and no multi-plug or
extension.is used.
Only
UK: The UK plug meets BS1363A standard
General information and tips:
After each installation or longer down time run at first
programme "Self Clean" with no load and added deter-
gent in washing agent compartment (2) to remove
possibly corruptive residues.
25
1.
2.