EN-46
Discrete I/O (for i-DT61XWE model)
4.9
Discrete I/O menu allows the configuration of 3 inputs and 4 outputs. The Discrete Input0 is located at J16 on
the mainboard (please refer to the Mainboard section for where it is located), while other Discrete Inputs &
Outputs are located at the Discrete I/O optional board.
Menu
Sub-Menu
Reset
TYPE
Discrete Input0
Discrete Input1
Discrete Input2
I.O.
Discrete
I.O.
Output1
Discrete
Output2
Discrete
Output3
Discrete
Output4
End
4.9.1 I/O Type
Set the status of the relay output.
OPEN
= the initial state of the relay output is normally open.
CLOSED
= the initial state of the relay output is normally closed.
Sub-Menu
Options
(in segment)
reset
no, yes
tYPE
OPEN, CLOSED
Off, Zero, Tare, Clear Tare,
INPUt0
Print, Unit, Accumulate, Start,
Reset, Start/Stop,
Pause/Resume
Off, Zero, Tare, Clear Tare,
INPUt1
Print, Unit, Accumulate, Start,
Reset, Start/Stop,
Pause/Resume
Off, Zero, Tare, Clear Tare,
INPUt2
Print, Unit, Accumulate, Start,
Reset, Start/Stop,
Pause/Resume
OUt1
Off, Overload, Underload,
Over, Under, Accept,
Under/Over, SP1, SP2, SP3,
SP4, Alarm
Off, Overload, Underload,
OUt2
Over, Under, Accept,
Under/Over, SP1, SP2, SP3,
SP4, Alarm
Off, Overload, Underload,
OUt3
Over, Under, Accept,
Under/Over, SP1, SP2, SP3,
SP4, Alarm
Off, Overload, Underload,
OUt4
Over, Under, Accept,
Under/Over, SP1, SP2, SP3,
SP4, Alarm
\
End
Defender 6000 Indicators
Options ( in segment)
NO, YES
OPEN, CLOSED
OFF, ZErO, tArE, CLr.tAr,
PrINt, UNIt, ACCUmM, StArt
rESEt, StA-SP, PA-rE
OFF, ZErO, tArE, CLr.tAr,
PrINt, UNIt, ACCUmM, StArt
rESEt, StA-SP, PA-rE
OFF, ZErO, tArE, CLr.tAr,
PrINt, UNIt, ACCUmM, StArt
rESEt, StA-SP, PA-rE
OFF, OU.LOAD, UN.LOAD, over,
UNDEr, ACCEPt, UN-OU,
F.SP1, F.SP2, F.SP3, F.SP4,
ALArmM
OFF, OU.LOAD, UN.LOAD, over,
UNDEr, ACCEPt, UN-OU, F.SP1,
F.SP2, F.SP3, F.SP5, ALArmM
OFF, OU.LOAD, UN.LOAD, over,
UNDEr, ACCEPt, UN-OU, F.SP1,
F.SP2, F.SP3, F.SP5, ALArmM
OFF, OU.LOAD, UN.LOAD, over,
UNDEr, ACCEPt, UN-OU, F.SP1,
F.SP2, F.SP3, F.SP5, ALArmM
/