Assembly Of Model As153; Selecting The Location; Leveling The Balance - OHAUS SL Serie Guide De L'utilisateur

EN-8

2.2.3 Assembly of Model AS153

1.Insert the Sub-platform on the mounting cone in the center of the balance.
2.Place the Weighing Pan on the Sub-platform.
3.Attach the Draft Shield by inserting the round bottom edge in the circular
recessed slot, as shown.
4.Place the metal cover on top of the Draft Shield.
Draft Shield Cover
Round Edge
of Draft Shield
Weighing Pan
Sub-platform
Mounting Cone
Circular Recessed
Slot

2.3 Selecting the Location

Locate the balance on a firm, steady surface. Avoid locations with excessive air
current, vibrations, heat sources, or rapid temperature changes.

2.4 Leveling the Balance

Before the balance is used, the feet should be adjusted so that the scale is
level with the surface. This will enable accurate weighing. You will see a level
bubble indicator in a small round window on the front of the balance. Level the
balance by adjusting the leveling feet so the bubble is centered in the circle,
as seen below.
Balance Level
Adventurer SL