Prior To Initial Start-Up - Electrolux ERT1000AOW Manuel D'utilisation

Screw
1
Low Hinge
2
Upper Hinge
3
Adjustable Low Foot
4
Adjustable High Foot
5
Screw Bolt
6
Plug
7
Decoration Block
8
The block of the top cover
9
Top Cover Plate
10
Screw nail
11
Electrical connection
– Before plugging in, ensure that the
voltage and frequency shown on
the rating plate correspond to your
domestic power supply.
– The appliance must be earthed.
The power supply cable plug is
provided with a contact for this
purpose. If the domestic power
supply socket is not earthed,
connect the appliance to a se-
parate earth in compliance with
current regulations, consulting a
qualified electrician.
– The manufacturer declines all
responsibility if the above safety
precautions are not observed.
– This appliance complies with the
E.E.C. Directives.
Changing the freezer compart-
ment door
Open the freezer compartment door a
little way. Using a small screwdriver,
press the spring in the opening of the
lower door bearing slightly upwards and
take the door bearing out complete with
the door.
1. Position the covering cap (M) on the
opposite side.
2. Turn the freezer compartment door
through 180 and fit the lower door
bearing into the lower bearing cavity
of the freezer compartment door.
3. Lift the freezer compartment door
a little way upwards, fit it into the
upper door bearing, and at the same
time insert the lower door bearing
into the square hole.
4. Small upward and downward adjust-
ments of the freezer compartment
door will make fitting easier.
M

Prior to initial start-up

Please clean the appliance interior and
all accessories prior to initial start-up
(see section: Cleaning and Care).
ENGLISH 7