Description Of The Appliance; View Of The Appliance; Starting Up And Temperature Regulation - Electrolux ERT1000AOW Manuel D'utilisation

8 www.electrolux.com

DESCRIPTION OF THE APPLIANCE

View of the appliance

Butter/cheese compartments
1
and egg storage insert
Door storage compartment
2
Bottle shelf
3
Vegetable drawers
4
Storage shelves
5
Temperature regulator
6
Freezer compartment
7
Rating plate
8

STARTING UP AND TEMPERATURE REGULATION

Insert the plug of the connection lead
into the plug socket with protective earth
contact. When the refrigerator com-
partment door is opened, the internal
lighting is switched on.
The temperature selector knob is lo-
cated on the RH side of the refrigerator
compartment.
Setting "0" means: Off.
Turning clockwise in direction "1"
Refrigerating unit on, the latter then
operating automatically.
Setting" 1" means: Highest tempera-
ture, warmest setting.
Setting "7" (end-stop) means: Lowest
temperature, coldest setting.
The temperatures in the refrigerator
compartment and freezer compartment
cannot be independently regulated.
At a low ambient temperature of around
16°C, setting'1' should be selected. At
ambient temperatures of around 25°C ,
select setting '2'.
If you require a lower temperature,
select setting '3'or'4'. On this setting,
you can be sure the fresh food will be
reliably frozen and that a storage tem-
perature of -18°C will be maintained in
the freezer compartment. If you want the
freeze fresh food rapidly, select setting
'7',ensuring that the temperature in the
refrigerator compartment does not drop
below 0°C. You should also promptly re-
set the temperature regulator to setting
'3' or '4'.
Important!
High ambient temperatures (e.g.
on hot summer days) and a
cold setting on the temperature
regulator (position'6' to '7') can
cause the compressor to run
continuously.
Reason: when the ambient temperature
is high, the compressor mustrun conti-
nuously to maintain the low temperature
in the appliance. The fridge will not be
able to defrost since automatic defros-
ting of the fridge is only possible when
the compressor is not running (see also
'Defrosting' section). The result is the
build up of a thick layer of frost on the
fridge rear wall.