Initial Start Up; Electronic Display Controls - Electronic Models Only; Controlling The Temperature - Electrolux END52800X Mode D'emploi

6 initial start up/electronic display controls – electronic models

Initial start up

The appliance transfers heat from food placed inside the
appliance to the outside air.
This process makes the rear, the sides and the area
adjacent to the doors, particularly at initial start up, feel
warm. This is normal.
There is a cooling coil located behind the rear wall of
the cabinet. This coil cools and removes moisture from
the air. A fan then circulates cold, dry air throughout the
cabinet.
This air circulation means that foods are refrigerated far
more quickly than in appliances where the air remains
relatively static.
Avoid placing food against air outlets as this will affect air
circulation (see diagrams on inside cover).
A light frosting will occasionally occur on the cold interior
of the freezer when the door is opened frequently. This
is normal and will disappear after a few days in most
climates.
Make sure you fully close the freezer door after you load
or remove food. If the door is left partly open, a heavy
frost will coat the inside of the freezer. If a frost develops,
remove it. Take care to properly close the door and the
frost will not reoccur.
Your new energy efficient appliance uses a high-speed
compressor and other energy efficient components that
may produce different noises to your old appliance.
These sounds are normal and include:
• compressor running noise.
• air movement noise from the small fan motor.
• occasional gurgling, similar to water boiling.
• a popping noise, heard during automatic defrosting.
• a clicking noise, just prior to the compressor starting
up.
These noises are normal and not cause for alarm.
Further details can be found on page 11.
tips and information
• On a top mount freezer (TM) refrigerator (where the
freezer is on top of the fresh food compartment):
Do not place food forward of the ribs on the bottom
of the freezer, it will keep the door open. So make
sure food is stored behind the ribs.
• On a bottom mount freezer (BM) refrigerator, single
door all refrigerator (AR) and single door all freezer
(AF):
Ensure freezer baskets and shelves are pushed
completely back to prevent them holding the door
open.
electrolux refrigeration
Electronic display controls – electronic
models only
The electronic display panel consists of an LCD display
with blue backlighting and 7 push buttons. When the
power is first turned on, you will see the default settings,
with the white backlighting on.
If no buttons have been pressed and the fridge door is
closed the backlighting will turn off after 30 seconds.
tips and information
A good indication of optimal freezer temperature is
ice cream that is frozen, but still soft enough for easy
scooping.
For the fridge compartment, we recommend using
drinking water and simply adjusting the fridge controls
until the water is at your ideal temperature.

Controlling the temperature

The default temperature for the refrigerator is 3°C, with
a default of -18°C for the freezer. If you want to change
the temperatures, use the instructions below. You should
make only small adjustments and wait 24 hours to see
whether you need to make further changes.
Note:
When you set a temperature, you set an average
temperature for the whole appliance cabinet.
Temperatures inside each compartment may vary,
depending on how much food you store and where you
place it. High or low room temperature may also affect
the actual temperature inside the appliance.
Changing the freezer temperature
Press the freezer button to make the freezer colder in 1°C
steps. Once -23°C is reached the display will return to -
14°C with the next button press. You'll notice that the bar
graph gets smaller with colder freezer settings.
Ribs
Changing the refrigerator temperature
Press the fridge button to make the fridge colder in 1°C
steps. Once 0°C is reached the display will return to 7°C
with the next button press. The bar graph gets smaller
with colder settings.