Unit Specifications; Unpacking And Installation - DENTSPLY TRIAD 2000 Mode D'emploi

DIMENSIONS
Height: .................... 12-1/8 in. (30.8 cm)
Width: .................... 7 in. (17.8 cm)
Depth: .................... 10-3/4 in. (27.3 cm)
Power Cord:............ 62 in. (157.5 cm)
WEIGHT
Domestic: .............. 10 lbs. (4.5Kg)
Export: .................. 15.5 lbs. (7.03 Kg)
UNPACKING AND INSTALLA-
TION
DO NOT CONNECT POWER CORD TO
OUTLET AT THIS TIME.
1. Remove unit from shipping carton and place
in the desired operating location.
2. Open the processing chamber door and
remove packing material.
NOTE: Save shipping and packing mate-
rials. If service is required at any time on
your Triad 2000 unit, you are respon-
sible for its safe* shipment back to
DENTSPLY. This is best accomplished
if the original shipping carton and pack-
ing materials are used.
3. Connect the POWER cord to an appropriate
power source.
4. Turn the POWER switch ON. The cooling
fan should operate.
5. With the access door closed, set the TIMER
dial to 1 minute. Depress the CURE switch
to ON. The lamp should illuminate.
6. Depress the TABLE switch to ON. The table
should rotate.
*Supply OSHA information re: Bloodborne pathogens policy on
shipping possible contaminated equipment for service.
4

UNIT SPECIFICATIONS

TRIAD 2000 LIGHT CURING UNIT
®
INSTALLATION
VOLTAGE/CURRENT .. 115V/2.35 AMP
FREQUENCY ................ 50/60 Hz
LAMP .......................... Special Tungsten Halogen
FIGURE 2
1. Lamp Access Door Thumbscrew
2. Lamp Mounting
3. Lamp Access Door
4. Optimum Curing "Sightline"
220V/1.5 AMP
230V/1.35 AMP
240V/1.3 AMP
(See Parts Listing section)