Maintenance; Remote Battery Installation - Napoleon Allure Phantom Serie Manuel D'installation Et D'opération

6.0 maintenance

EN
WARNING
!
• In preparation for maintenance, always disconnect the power and allow the electric appliance to cool before
performing any cleaning, maintenance, or relocation of this electric appliance. Turn controls to off and remove
plug from outlet or turn off the house circuit breaker to electric appliance receptable.
• Do not install replacement lamps that exceed specified maximum watts.
• The LED lights in your appliance can become hot. Allow at least 10 minutes between turning off the appliance
and removing the lights to avoid accidental burns.
• Do not handle the lights with care fingers, as oils from your skin will damage the lights when they heat up. Use
gloves or a clean dry cloth when handling lights.
6.1

remote battery installation

note:
The remote control has a removable plastic tab to prolong the battery life while shipping. Remove the tab for the
remote control to function.
1. To replace the existing battery, remove the battery
holder.
2. To remove the battery holder, turn remote onto
front side and press the left side lever towards the
center while pulling the battery holder out using
the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position.
4. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
20
W415-2172 / D / 10.30.20
BATTERY (CR 2025)
BATTERY HOLDER
REMOTE
(REAR SIDE)