Intended Use - Oase Water Starlet Notice D'emploi

- EN -
1 „Water Starlet" (fully assembled), 1 transformer

Intended use

Only use the product described in this manual as follows:
• For creating a water fountain in lakes or large ponds with or without fish.
• For operation with clean water.
• Use for private purposes only.
• Operate in accordance with instructions.
The following restrictions apply to the unit:
• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Do not connect to the domestic water supply.
Installation, connection and alignment
W A R N I N G
Electrical current may cause death or severe injuries.
• For use, install the transformer at a minimum safety distance of 2 m from the bank (A).
• Choose an installation place for the transformer that is splash-water protected. Also protect the transformer
against sun radiation (max. 40 °C).
Installation variants (B)
The unit can be installed floating or standing in the water.
• When used floating, the unit position is fixed by bracing cords fastened at the eyelets (1) at the bottom of the unit
• When used standing, place the unit horizontally in the water (3) on a firm ground (4); level with rocks, if necessary.
Please note that the unit has to be installed at an approx. 80 mm water depth. If placed too deep in the water, safe
hold is not guaranteed due to buoyance.
Note:
• Ensure that the water inlet at the unit underside is not impaired.
• The floating bodies can be removed for a safer stand of the unit.
Connection (C)
Connect the unit and the transformer using the two-pole plug (6). Fasten the plug using the union nut (7).
Alignment (D)
Adjust the individual movable nozzles to align the water jet (8).
Commissioning/start-up
N O T E
Prevent the pump from running dry. Otherwise the pump will be destroyed.
• Only operate the pump when it is immersed.
Switching on the unit: Plug the power plug of the transformer into the socket. The unit switches on immediately.
Switching off the unit: Disconnect the transformer power plug.
T I P
The water feature patterns of the Water Starlet are default programmed. The program cannot be altered.
10