Abus TVVR50000 Mode D'emploi page 24

There are three recording modes for each camera:
Stream 1 for continuous recording
Stream 2 for event recording
Stream 3 for network access
Each stream type can be configured individually as shown in the
following steps.
BitRate Type / Max. BitRate (Kbps): These settings are used primarily in stream
3. If the Variable bit rate type is selected, then the bit rate varies according to the
image. If Constant is set, then transmission is made exclusively with the set bit
rate. This may have a negative effect on image quality. A lower bit rate is generated
when a sequence of similar images is recorded, whilst a higher bit rate is gener-
ated when a sequence of different images is recorded.
MA-4101-002-Bedienungsanleitung-TVVR50000+TVVR60000.indb 24
Stream Type: Select whether both video and audio or video only
should be recorded or transmitted.
12
Resolution: Select the image resolution here. 4CIF has the high-
est resolution and QCIF the lowest.
To copy the set properties to other cameras, select the corre-
sponding cameras and click Copy. Click Apply.Click on the
15
Schedule tab.
Video Quality: The more crosses are selected, the better the
video quality.
13
Frame Rate: The frame rate depends on the resolution. The
higher the frame rate and resolution, the greater the recorded or
transmitted data quantity.
Select the camera where the schedule should be defined. The
overview graphic shows the recording time and type for the se-
16
lected camera.
14
17
16.09.2010 11:23:10