Functions - Storch DMS 25 Mode D'emploi

Technical description of the machine
STORCH DMS 25 Flow Mixer is suitable for processing
all pre-mixed and machine-compatible dry mortars.
Adhesive mortar, fine concrete, liquid screeds, and brick-

Functions

The flow mixer comprises a storage tank which is sepa-
rate from the mixing pipe. During operation, the dry
material is fed into the mixing pipe by means of the
Safety
Prior to the initial operation of the machine, the operating
instructions have to be studied carefully.
Trained and instructed staff only may be employed on the
machine.
The operating staff is responsible for the maintenance
and servicing. The machine has to be checked for notice-
able damage in regular intervals (prior to every startup, if
possible).
The device possesses a voltage range which can pose an
electrical hazard to humans and animals. It should only be
opened and/or disassembled by authorised persons.
No modifications, such as changes or extensions, may be
carried out on the machine.
Use original spare parts only as otherwise the perfect
function of the machine is not ensured. If you do not use
original spare parts, risks to persons and property cannot
be ruled out.
The machine can only be operated on the mains power,
if all rotating sections have been secured by closing and
safeguarding the corresponding components.
The machine must set up so as to rule out rolling or tip-
ping over.
The machine may be serviced only by trained specialist
staff.
The machine may be operated in a technically perfect
condition only for the intended purpose adhering to the
work mortar, for example, can be mixed. The flow mixer
is exclusively loaded with bagged goods (dry material).
transport/dosing shaft. In the mixing pipe, the mortar is
mixed after water has been added.
instructions in the operating instructions.
Wear work gloves and protective work shoes during
assembly and disassembly work.
In case of longer breaks/interruptions and absence of the
operating staff, clean the machine after disconnecting
from the mains and locking against switching back on.
Also disconnect the machine from the mains and lock
against switching back on if machine components, such as
the mixing pipe or safety guards, are opened for cleaning.
During cleaning of the machine, protect the electric con-
nections against direct contact with water.
Operate the machine through a residual current circuit
breaker with earth monitor only.
For cleaning work, always disconnect the machine from
the mains.
Do not reach into the material outlet when the machine is
running.
The machine has not been fitted with a suspension device
for crane transport!
Observe the general safety and accident prevention regu-
lations for the building trade.
Never reach into the running machine!
35 Translation of the original instruction