Philips Saeco Xelsis SM7686 Mode D'emploi page 24

English
24
Problem
The coffee is not hot
enough.
Coffee does not come
out or coffee comes
out slowly.
The milk does not
froth.
Cause
The grinder is set to a too
coarse setting.
The coffee settings have
been adjusted.
The machine is performing
its self-adjustment
procedure after a change in
grinder settings or bean
types.
The cups you use are cold.
The temperature is set too
low. Check the menu
settings.
You added milk.
The AquaClean filter was not
prepared properly for
installation or it is clogged.
The grinder is set to a too
fine setting.
The brew group is dirty.
The coffee dispensing spout
is dirty.
The machine circuit is
blocked by limescale.
The internal cappuccinatore
is dirty or not inserted
correctly.
Solution
Set the grinder to a finer (lower)
setting.
Select your coffee drink and adjust
the settings to a stronger coffee.
Brew a few cups of coffee.
Preheat the cups by rinsing them
with hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
Remove the AquaClean filter and try
to brew a coffee again. If this works,
make sure the AquaClean filter is
prepared properly before you place
it back. Place back the prepared
filter. If this still does not work, the
filter might be clogged and needs to
be replaced.
Set the grinder to a coarser (higher)
setting.
Clean the brew group.
Clean the coffee dispensing spout
and its holes with a needle.
Descale the machine.
Clean the internal cappuccinatore
and make sure that you position and
insert it correctly (see 'Cleaning the
internal cappuccinatore under the
tap').