Handling The Brew Group; Reinserting The Brew Group - Philips Saeco Xelsis SM7686 Mode D'emploi

English
16
1 Open the lid of the bean hopper.
2 Press down the grind setting knob and turn it to the left or right (Fig. 18). Turn the grind
setting knob one notch at at time. Each time you have turned the grind setting one notch,
brew a coffee drink to prevent damage to the grinder.
3 Close the lid of the bean hopper.
Adjusting default settings
Use the SETTINGS icon to change the following settings:
- AquaClean: To check the status of AquaClean and install a new one.
- Water hardness: to be able to adjust the machine settings to the water in your region,
please measure the water hardness.
- Stand-by time: this is the time after which the machine goes into stand-by mode.
- Brightness: to adjust the display contrast
- Water tank light: to adjust the light in the water tank
- Coffee spout light: to adjust the light illuminating the cup tray.
- Language: to select a different language
- Measurement unit: to select millilitres or US fluid ounces
- Sound feedback: to activate/deactivate the sound feedback of the display,

Handling the brew group

Go to www.saeco.com/care for detailed video instructions on how to remove, insert and
clean the brew group.
Removing the brew group from the machine
1 Switch off the machine by pressing the main switch on the back of the machine.
2 Open the service door (Fig. 19).
3 Remove the coffee residues drawer (Fig. 20).
4 Press the PUSH button (Fig. 21) and pull at the grip of the brew group to remove it from the
machine (Fig. 22).

Reinserting the brew group

Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the arrow on the yellow cylinder on the side of the brew group is aligned with the
black arrow and N (Fig. 23).
- If they are not aligned, push down the lever until it is in contact with the base of the
brew group (Fig. 24).
2 Make sure that the yellow locking hook on the other side of the brew group is in the correct
position.
- To position the hook correctly, push it upwards until it is in uppermost position (Fig. 25).
3 Slide the brew group back into the machine along the guiding rails on the sides (Fig. 26)
until it locks into position with a click (Fig. 27). Do not press the PUSH button.
4 Place back the coffee residues drawer and close the service door.