Electrolux IK1555CR Notice D'utilisation page 56

56 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the ,FastCool or
after changing the temper‐
ature.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastCool function is
switched on.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The FastCool function is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "FastCool func‐
tion".
The compressor starts af‐
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off FastCool man‐
ually, or wait until the func‐
tion resets automatically to
set the temperature. Refer
to "FastCool function".
Keep the button pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".