Programming Cleaning Cycles - Zodiac Vortex Notice D'installation

3.7.2 Programming cleaning cycles

Program up to 7 cleaning cycles (for example, 2 days per week: Wednesdays and Saturdays over 4 weeks).
• You must set the ti me before you program the cleaning cycles, see § "3.7.1 Setti ng the ti me".
• Start by selecti ng the cleaning cycle on the control box, see § "3.5.1 Cleaning cycle selecti on (depending on model)".
• Then program the days, hours and minutes.
DAY
Press for 3 seconds
The days of the week fl ash twice.
The LED and the current
date and ti me fl ash to remind you.
Press to start programming
Select the day with
or
Press to confi rm,
• The programming stops automati cally at the end of the 7th cleaning cycle and the LED
• To cancel ALL the programming, exit the menu
Tip: check the programming
Press . Each programming is displayed for 3 seconds.
13
HOURS
The hours start to fl ash
Select the hour with
or
Press to confi rm,
To cancel a day's programming,
hold down unti l the
display changes.
and hold down
MINUTES
The minutes start to fl ash
Select the minutes with
(every 1/4 hour)
Press to confi rm,
Exit the menu by pressing
or
switches off .
unti l the display changes.
or