I Electricity Supply Connecti Ons - Zodiac Vortex Notice D'installation

3.4 I Electricity supply connecti ons

To prevent risk electrocuti on, fi re, or serious injury, be sure to adhere to the following:
• Use of an electrical extension is prohibited when connecti ng the control box.
• Make sure that the socket can be easily accessed at all ti mes and is protected from rain or
splashes.
• The control box is splash-proof but must not be immersed. It must not be installed in a
fl oodable area; keep it at least 3.5 metres away from the edge of the pool and avoid exposing
it to direct sunlight.
• Place the control box near the socket.
• Unscrew the protecti ve cap (see image
• Connect the fl oati ng cable to the control box and lock it in place by turning the ring only in the clockwise directi on (to
prevent damage to the fl oati ng cable) (see image
• Make sure that the connector is fully pushed in so that no water can get in (see image
• Connect the power cord (see image
mum residual current device (if in doubt contact a qualifi ed technician).
Tip: choose the locati on of the control box carefully to prevent the cable from becoming tangled
Place the control box in the centre of the pool's length, following the safety conditi ons relati ng to the
electrical connecti on. This lets you limit the length of the fl oati ng cable to be put into the water to cover the
pool, which simplifi es set-up and storage operati ons.
9
).
, ).
). Only connect the control box to a power outlet protected by a 30 mA maxi-
).