General; Symbol Assertion; Safety Instructions - E+E Elektronik EE99-1 Série Manuel

1.

GENERAL

The manual is a part of the scope of supply and serves to ensure proper handling and
optimum functioning of the instrument.
®
E+E Elektronik Ges.m.b.H. doesn't accept warranty and liability claims neither upon this
publication nor in case of improper treatment of the described products.
For this reason, the manual must be read before start-up.
In addition, the manual is for all personnel who require knowledge concerning transport,
setup, operation, maintenance and repair.
The manual must not be used for the purpose of competition without a written consent
®
from E+E Elektronik and must also not be forwarded to third parties.
Copies for personal use are permitted.
The document may contain technical inaccuracies and typographical errors. The content
will be revised on a regular basis. These changes will be implemented in later versions.
The described products can be improved and changed at any time without prior notice.
© Copyright E+E Elektronik
1.1

Symbol assertion

This symbol indicates a safety instruction.
These safety instructions should always be followed carefully.
By not following these instructions injuries of persons or material damage could happen.
Therefore E+E Elektronik ® does not accept liability.
This symbol indicates a note.
These notes should be followed to achieve optimum functioning of the equipment.
1.2

Safety instructions

General safety instructions
•
Extreme mechanical stress and improper use must be avoided.
•
Be careful when removing the filter cap to avoid damage of the sensor element.
•
The sensor is an Electro Static Discharge sensitive component (ESD). When
touching the sensor element, ESD protective measures should be followed.
•
Hold the sensor on its connection wires only.
•
Installation, electrical connection, maintenance and start-up procedures should
be executed by qualified technical personel only.
Safety instructions for using the alarm output module with
voltages >50V
•
For the separation of the alarm output module from the connecting terminals the
therefor designated partition must be mounted in the bottom.
•
During operation the housing of transmitter must be closed.
•
Work on live parts is to be omitted basically and may only be executed by
trained personnel. The protection class of the opened housing is IP00.
Components with dangerous voltages can be touched directly.
®
Ges.m.b.H.
9
All rights reserved.