Locking Commands - Thermor Cascade 2 Notice D'installation Et D'utilisation

5) Locking commands

It is possible to lock the knob
dren...).
1
1- Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
c) Detach pin P from its stand using a cutting tool.
d) Set pin P in the alignment of arrow B (2).
e) Refit the cap.
2- Limitation of the knob's use range:
a) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
b) Remove the two P pins from their stand using a cutting tool.
c) Position the two P pins at each end of the operating range desired (3).
d) Refit the cap.
or restrict its use, preventing untimely handling of the device (chil-
2
P
19
3
P
B
L
GB