Set Indoor Unit Filter Cleaning Alarm - AERMEC WRC1 Manuel De L'utilisateur

EN

Set indoor unit FILTER CLEANING alarm:

This function is used to set a certain number of operating hours after which the unit will send a message requesting that the air
fi lter be pulled out and cleaned (for the fi lter removal and cleaning procedure, refer to the indoor unit installation manual); to set
this function (with the unit ON), perform the following operations:
(1)
press the "FUNCTION" key until the Clean Filter icon appears (
The wording "set" will also appear with the current value set for the function;
(2)
press buttons (
with each level, refer to the table in the diagrams at the bottom of the page);
(3)
press the "SWING/ENTER" button again to activate the selected function;
(1)
(3)
62
) or ( ) to set a value for the desired level (to fi nd out the corresponding number of hours associated
); at this stage, the selected icon will begin to fl ash;
(2)
Set period
fi lter cleaning
WARNING: the system indicates that fi lter cleaning is
underway by displaying the relative icon
To reset the message (and resume hour metering), press the
"FUNCTION" bu on un l the CLEAN func on is selected in the
same way as for the opera ons described above at point (1)
and then press the "SWING/ENTER" bu on
Long period Medium period
SET Hours SET
10 20
5500
11 21
6000
12 22
6500
13 23
7000
14 24
7500
15 25
8000
16 26
8500
17 27
9000
18 28
9500
19 29
10000
NB: if the value 00 is set (default value), this function
will be disengaged.
Short period
Hours SET Hours
30
1400 100
31
1800 200
32
2200 300
33
2600 400
34
3000 500
35
3400 600
36
3800 700
37
4200 800
38
4600 900
39
5000 1000