One for All URC3610 Mode D'emploi page 8

SETUP
Deleting a learned function
If you want to delete a learned function and return that key to its
original state, you can use the following procedure:
1.
2.
3.
SOUND BAR / AUDIO RECEIVER VOLUME
CONTROL
If you have your TV connected to a Sound Bar or Audio Receiver, it's
possible to set up your Essential remote to control the Volume and
Mute of this device. There are two ways to do this:
AUDIO SIMPLESET
If you have a Sound Bar or Audio Device from one of the brands listed
in the table below, you can use the SimpleSet method to program your
remote to control it. If you do not have one of the below brands, please
proceed to the next section.
Note that each of the brands has a digit associated with it,
for example 5 for LG.
To set up your remote to control your sound bar / audio device, first
make sure your TV and sound bar / audio device are both powered on,
and that there is something playing that you can hear (this procedure
will test the Mute function). Next:
1.
2.
712847 Essential-TV CAN_Manual URC3610 RDN1111220 incl. Codelist.indd 8 712847 Essential-TV CAN_Manual URC3610 RDN1111220 incl. Codelist.indd 8
Hold down the SETUP key until the LED
blinks twice
Press 976 – the LED should blink twice
Press the key you want to reset twice – the LED should blink
twice and the learned function has been deleted.
Bose
Denon
Harman/Kardon
JBL, Polk Audio
LG
Onkyo
Samsung
Sonos, VIZIO
Sony
Yamaha
Hold down the SETUP and VOLUME UP buttons
together until the LED blinks twice.
Now point the remote towards your sound bar /
audio device and hold down the digit key for your
brand (for example 5 for LG). The remote will send
the Mute command to your device every 3 seconds.
8
11-12-2020 12:18 11-12-2020 12:18