Description Of Symbols - Triton Dual Mode Precision TRA001 Instructions D'utilisation Et Consignes De Sécurité

Introduction
Thank you for purchasing this Triton tool. Please read these instructions: they contain information necessary for safe and effective operation of this product. This product
has a number of unique features and even if you are familiar with similar products, reading the instructions will help you get the full benefit of its unique design. Keep these
instructions close to hand and ensure all users of this tool have read and fully understand them.

Description of Symbols

The rating plate on your tool may show symbols. These represent important information about
the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Caution
Warning: Sharp blades or teeth!
DO NOT use in rain or damp environments!
Always disconnect from the power supply when adjusting, changing accessories,
cleaning, carrying out maintenance and when not in use!
Dust extraction required or recommended
Class II construction (double insulated for additional protection)
Environmental Protection. Waste electrical products should not be disposed of
with household waste. Please recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
Conforms to relevant legislation and safety standards.
248014
GB
4
Original Instructions
Specification
Model no:
Voltage:
Input Power:
No-load speed:
Collet:
Maximum cutter diameter:
Maximum collet size:
Height adjustment:
Plunge Range:
Ingress protection:
Protection class:
Power cord length:
Dimensions (L x W x H):
Weight:
As part of our ongoing product development, specifications of Triton products may alter
without notice.
WARNING: Always wear ear protection where the sound level exceeds 85dB(A) and limit the
time of exposure if necessary. If sound levels are uncomfortable, even with ear protection, stop
using the tool immediately and check the ear protection is correctly fitted and provides the
correct level of sound attenuation for the level of sound produced by your tool.
WARNING: User exposure to tool vibration can result in loss of sense of touch, numbness,
tingling and reduced ability to grip. Long-term exposure can lead to a chronic condition. If
necessary, limit the length of time exposed to vibration and use anti-vibration gloves. Do not
operate the tool with hands below a normal comfortable temperature, as vibration will have a
greater effect. Use the figures provided in the specification relating to vibration to calculate the
duration and frequency of operating the tool.
A poorly maintained, incorrectly assembled, or misused tool, may produce increased levels of
noise and vibration.
TRA001
120V~ 50/60Hz,15A
3¼ Peak hp
8000 - 21,000min -1
½" & ¼"
55mm (50mm when used with WX7RT001)
½"
1) Free Plunge 2) Table Height Winder
3) Micro Adjuster (Fine Adjustment)
0 - 2 ⁄ "
3
5
IP20
3m
180 x 300 x 310mm
16.64lbs