Cleaning Process; Clean The Leaf Canister - Maytronics Dolphin Hybrid RS 1 Mode D'emploi

Cleaning Process

❙ ❙
The Dolphin Hybrid Cleaner continues to clean
your pool as long as the pool pump is operating.
The time required to cover all pool surfaces depends
on the pool size. In general, 1-2 hours are sufficient.
During operation, refer to the indicator lights
(Drawing G) on the cleaner to make sure that the
Dolphin Hybrid Cleaner is functioning properly
(see table below).
Table 2: Indicator Lights
Light
Red (2 sec.)
Blue — slow blinking
Blue — fast blinking
Blue and red (2 sec.)
Red — blinking

Clean the Leaf Canister

❙ ❙
1 Make sure the pump is OFF.
2 Disconnect the Leaf Canister and hold the
adjacent Hose Section.
3 Open the lid by turning it anticlockwise
4 Remove the filter.
5
Clean out leaf and other debris (Drawing H).
6
Rinse the filter.
7 Return the filter and lid.
8 Connect the Leaf Canister and hose
sections under the water. Make sure to
remove trapped air from the Leaf Canister.
9
Turn the pump ON.
I
Canister
6
_book_8151171_Dolphin_Hybrid_v2.indb 6
Indication
Start of operation
Proper functioning — The Dolphin Hybrid Cleaner is moving forward.
Proper functioning — The Dolphin Hybrid Cleaner is making a turn.
Proper functioning — The Dolphin Hybrid Cleaner identifies a wall.
• Insufficient flow — To correct unsatisfactory flow, refer to Table 1.
• Use the Troubleshooting Guide (Table 3).
Canister
Lid
Leaf & debris
Filter
Dolphin Hybrid RS 1 - Suction Pool Cleaner
H
|
G
Operating Instructions
17/6/2012 1:34 PM