Display; Install - Pioneer A-10-K Mode D'emploi

> Before Start > Part Names

Display

1. The input mode is displayed.
(USB Front / USB Rear / Music Server / Network)
2. The name of the file, artist, album, etc., is displayed.
3. Displays the play status.
4. Displays file format, sampling frequency, and quantization bit information.
5. The file play status is displayed. This may not be displayed depending on the input or file.
6. Lights in the following conditions.
: When the connection setting on the unit is "Wired" and the unit is connected to the network.
: When the connection setting on the unit is "Wired" and the unit is not connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is not connected to the network.
7. If an album jacket is recorded for the file being played, it is displayed here.
8. Lights in the following conditions.
: When all track repeat play is on
: When one track repeat play is on
1
6
> Install > Initial Setup

USB Front
Song

Artist
Album

FLAC

44.1 /24
kHz bit

00:01:45 / 00:03:23
> Playback
Supplementary information | Advanced Setup | Others



: When shuffle play is on
0 When DISPLAY on the remote controller is pressed to turn off the display, the unit may
appear the same as if you had unplugged the unit from the power outlet, but electricity is
still being supplied to the unit. To completely cut the unit off from the power supply, you
need to unplug the power plug (shutoff device) unit from the power outlet.
E
N