Pioneer A-10-K Mode D'emploi page 100

> Before Start > Part Names
Wireless
Scan Networks
Use iOS Device
Input SSID
0 To redo the initial settings, press SETUP on the remote
controller, select "Wi-Fi" in "Network Setting" -
"Connection", then select "Wi-Fi Setup".
∫ Scan Networks
From the list of SSID for access points such as wireless
LAN routers, select the required SSID and make the
settings.
1. Select the SSID of the access point you want to connect
and then confirm.
Wireless
aaaaaaaaaaaaaaaa
bbbbbbbbbbbbbbbbb
ccccccccccccccccccc
ddddddddddddddddd
2. Select either "Enter Password" or "Push Button" and
confirm. If the access point has an automatic setting
button, by selecting "Push Button" you can connect
without entering a password.
> Install > Initial Setup
Wireless
Enter Password
Push Button
3. If you select "Enter Password", enter the password of the
access point and press ENTER. For details on how to
enter text, refer to "Entering text" (
Password
A
[REPEAT] Change Text
[CLEAR] Delete One Character
If you select "Push Button", then after pressing and holding the
automatic setting button on the access point for the required
amount of time, press ENTER on the remote controller.
4. is displayed when the settings are complete.
∫ Use iOS Device
Set by sharing the iOS device's Wi-Fi settings with this unit.
1. Connect the iOS device by Wi-Fi.
2. Select this device in the "SET UP NEW AIRPLAY SPEAKER..."
item on the screen of the iOS device and select "Next".
0 This unit is displayed as "Pioneer N-30AE XXXXXX".
3. After establishing the connection, select "Done" on the
screen of the iOS device.
> Playback
Supplementary information | Advanced Setup | Others
4. is displayed on the display of the unit when the
settings are complete.
∫ Enter SSID of the access point
Set by entering the SSID of the access point you want to connect.
1. Enter the SSID. For details on how to enter text, refer to
"Entering text" (
P19).
2. Select and confirm the authentication method.
0 If you select "None", proceed to step 3. If you select "WEP",
"WPA", or "WPA2", enter the password and confirm.
3. is displayed when the settings are complete.
P19).
SSID
A
[REPEAT] Change Text
[CLEAR] Delete One Character
Security Method
None
WEP
WPA
WPA2
E
N
11